This USB Type-C voltage transmission deception trigger is suitable for 5V 9V 12V 15V 20V voltage, which can meet the wide range of needs from low-power devices (such as Bluetooth headsets) to high-power devices (such as laptops).
The module size is 30x20mm, suitable for mobile hard disks and display devices with USB-C interfaces such as solar phones, computers, and tablets. When a specific voltage input is required, this trigger can also be used for adaptation.
Voltage adjustment method: According to the table on the back of the board, adjust the dip switch to control the voltage output.
Note: After adjusting the dip switch, since there is no voltage indicator, it is recommended to use a multimeter to measure the voltage before connecting to the application circuit. If the dip switch is not adjusted according to the table, the module will output any of the above voltages.
Through specific circuit design and software algorithms, the trigger can "cheat" or simulate the voltage required by the device, so that it can work normally in a specific voltage environment. This is especially useful for some devices that require a specific voltage input to work.
4pcs Dual USB Buck Converter 9V 12V 24V to 5V 3A Charging Module Power Buck Converter Voltage Regulator DIY Car Charger Modules
KWD 3.500
2PCS SOP8 SOIC8 SO8 SOP8 to DIP8 Programming Adapter IC Socket Converter Module Programmer Adapter 24 * 20mm Socket Converter 150mil
KWD 5
DMiotech Heat Shrink Tube Electrical Insulation Tube 3:1 Cable Wire Tubing Sleeving Wrap Blue 1inch Diameter 4ft Long
KWD 3
2Pcs 5V XH-M131 Photosensitive Resistor Module Light Control Module Light Control Switch Photoresistor Relay Module Brightness Automatic Control
KWD 4
