ALL-IN-ONE INTEGRATED HEATED SURFACE — Unlike traditional 4-layer setups (spring steel + magnetic sheet + aluminum plate + PCB heater), Aetnus combines the heater, build surface, and thermal insulation into one single graphene-composite panel. This eliminates the need for separate magnetic sheets or adhesive PEI layers, reducing Z-axis stack height and simplifying your Bambu Lab P1S/P1P/P2S/X1C/X1E/X2D, or A1 setup. One plate. Zero assembly headaches
40% FASTER HEAT-UP — VERIFIED LAB DATA — Powered by graphene far-infrared radiation technology (99.15% electric-to-thermal conversion), this build plate reaches 60°C in just 30 seconds and 100°C in 40 seconds — up to 40% faster than the stock Bambu Lab aluminum heated bed. Start printing sooner, reduce idle time, and boost your daily print throughput without any firmware modifications
SUPERIOR THERMAL UNIFORMITY — <5°C DEVIATION — Say goodbye to edge warping and first-layer adhesion failures. Independent thermal imaging tests confirm less than 5°C temperature deviation across the entire 257×257mm print area at 60°C, and less than 10°C at 100°C — over 20% more uniform than standard aluminum beds. The tempered glass substrate maintains flatness under heat with near-zero thermal deformation (thermal expansion coefficient 62% lower than aluminum), ensuring dimensionally accurate prints every single time
DIAMOND TEXTURED COATING — PRINT & POP RELEASE — The proprietary crystal-diamond coating is engineered for optimal adhesion during printing and effortless model release upon cooling — no glue stick, no hairspray, no scraping. Validated for 2,000+ hours of continuous printing with PLA, ABS, PETG, TPU, ASA, and PC with zero coating degradation. Simply cool to 40°C and flex-free models pop right off. Clean with 75% isopropyl alcohol between prints to maintain peak performance
15-MINUTE PLUG & PLAY INSTALL — 20,000-HOUR LIFESPAN — Designed as a direct drop-in replacement for the stock Bambu Lab 257×257mm heated bed. No soldering, no firmware changes, no rewiring — just swap, connect the terminal block, run auto-calibration, and print. Built to last with 20,000+ hours of rated operational life (tested at 150°C continuous), impact-resistant tempered glass (survives 50g ball drop from 50cm), and 12.5kg load-bearing capacity. Backed by Aetnus quality assurance with responsive technical support
3D Printer Enclosure Kit for FLASHFORGE Adventurer 5M, Constant Temprature,Reducing Noise and Dustproof, DIY Enclosure Kit,Supports High Temperature Filaments Printing, Like ABS, ASA and PC
KWD 15
3D Printer Adhesive Glue, Professional Original 3D Print Glues for Hot Bed Weld, Strong Grip Reduces Warping for ABS, PLA, PLA+, PETG and TPU Flex Filament,No Residue, Durable Than Stick-120mL 4 fl oz
KWD 6
6pcs Upgraded Anti Vibration Feet Kit for 3D Printer Lab X1/X1C/P1P/P1S, Anti-Slip Shock Absorbing Pad 3D Printer Accessories Protecting 3D Printer Parts Reduces Vibration Improves Print Quality
KWD 0
Thermistor Kit for Bambu Lab P1P/P1S, 300°C High Temperature Thermistor & Retaining Clip Hotend Replacement Parts for 3D Printer Accessories
KWD 4
