The 2002-2005 Factory Bezel is designed to house Single Din Radios only. Therefore modifications are necessary to install larger Double Din Radios. Modifying is completed by hand and often includes cutting the Factory Bezel, filling it with bondo or fiberglass, then sanding and painting or using vinyl to cover. This process is time consuming and costly, until now. This is the only one piece Double Din Dash Kit available for purchase on the market. This Dash Kit eliminates the need of shipping off your Factory Bezel for a week's worth of modifications that can cost $200-$250. Unlike the modified Bezels this Dash Kit is made up of only one material that will not break or crack when subjected to continuous heat and comes complete with installation brackets, wire harness and antenna adapter for the installation of an Aftermarket Radio. Basic Installation Directions: Separate the Single Din face plate from the main Dash Bezel then 2-part epoxy (included in kit) the new Double Din Dash Kit to the main Dash Bezel. Detailed Installation Directions: (1) Disconnect the negative battery terminal (2) Unclip the top edge of the trim panel below the steering column (3) Remove the one Philips head screw from below the right A/C vent (4) Unclip and remove the dash trim panel (5) Remove the 4 Philips screws that secure the radio, disconnect and remove the radio (6) Remove the 4 Philips screws that secure the A/C controller (7) Remove the 4 Philips screws that secure the factory pocket (8) Locate the 11-PVC welds and with a ¼ drill bit drill each PVC weld out, you can drill right through the old face plate(9) Slide a flat head screw driver between the old face plate and the main Dash Bezel to separate. (10) Bond the new Double Din dash kit and the Main Dash Bezel together with 2-part epoxy. *Be sure to save all screws removed during installation process as they are reused.