Product Details:
UV energy meter is used to measure the UV energy of different light sources, especially for printing machines. To ensure that the printing and drying process to achieve the desired quality control.
Energy meter can measure the spectral ran: 250-410 nm, the best sensor peak spectral output of 365 nm.
The amount of light that is incident when the exposure cycle is added, and the relative value is taken into account.
Due to the irregular distribution of light sources, and different manufacturers have different structural design. So that different readings may occur under the same measurement conditions.

Specifications and parameters:
Model: UV-intergator 150 UV tester
Size: Diameter 90mm high 12mm
Weight: about 150g
Applicable equipment: UV energy detection of UV drying machine, exposure machine, conveyor belt, UV lamp, UV curing machine and other equipment
Measuring ran: 0-5000mW / cm2
Energy display: LCD 0-999999mj / cm2
UV wavelength measurement ran: 250-410nm (spectral wavelength) peak 365 nm
Operating temperature: (degrees) 0-70 degrees, high temperature 100-110 degrees no more than 10 seconds

Introductions:
1. Turn the switch on the right side of the meter to the "ON" position, and the display will show the number "0" mj / cm2 (mJ / cm2) on the display.
2. Prepare the measurement, the energy meter sensor window facing the UV light source to ensure the effectiveness of the measurement.
3. When the instrument is irradiated for a certain time after the light source, the sensed UV UV energy has been recorded. At this time, the energy value can be read from the display screen on the front of the instrument. The corresponding unit of energy is: mj / cm2 (mJ / Square centimeters).
4. Each time you peorm a new measurement work, turn the instrument off as needed and then turn it on again. The display will be re-adjusted to "0" mj