The Free Tilter FT-02 allows you to freely adjust the up-down angle and left-right swing of lighting equipment using the grip handle. It is made from a carbon fiber column and weighs only about 290g. It can be set up quickly, greatly improving the efficiency of your photography. It is particularly useful for adjusting lighting equipment that has been set up in a high place that is out of reach.

■Made from carbon fiber, weighing only about 290g.

■The angle of the column and the swing of the head can be adjusted
The angle of the column and the swing of the head can be adjusted easily using the grip handle. The locknuts can be tightened to fix the column at any angle.

■The height can be adjusted using the two-stage column
The two-stage column can be extended and retracted to allow the strobe to be set up at a higher position than with a light stand.

■Maximum vertical load 1.5kg
However, the maximum vertical load when the column is extended is 0.9kg.

■Length when stored is 45.5cm
It can be stored compactly and is convenient for carrying around. It can be stored together with a 50cm light stand.

■Precautions for use
Please be sure to observe the following points to ensure safe use of this product.

Maximum load
・The maximum vertical load for the Free Tilter FT-02 is 1.5kg. However, the maximum vertical load when the column is extended is 0.9kg.
The maximum vertical load refers to the maximum load that the equipment can temporarily withstand in the vertical direction (directly below). The design standard for the FT-02 is that it can withstand this load for 2 hours.
Selecting and setting up a light stand
・Please use a light stand with a maximum load of 3kg or more.
・Please do not use a light stand with short legs. When setting up, take into account the center of gravity and the direction of the legs so that the light stand does not tip over towards the subject, etc. When extending the column of the Free Tilter, do not tilt it more than 45 degrees from the vertical.
Safety Checks
During shooting, check regularly that the center column of the light stand is not tilted and that the locknuts are not loose.
WARNING
If you leave your equipment unattended, there is a risk of damage or it tipping over. Be sure to keep an eye on it and maintain safety.