Compatible with Anycubic Photon Mono M5

Package included: 5 PCS 320*220mm FEP Release Film + 5 PCS 10.1'' 3D Printer Screen Protector

FEP Release Film Specification:

- UV transparency: Exceeds 95%

- Size: 320 * 220mm

- Thickness: 0.15mm

- Heat resistance: -240 ° C to 205 ° C.

- High ductility: 300%of ductility

- Good flexibility: 10,000 bend tests

- Stable release force: Coating uniformity

- Smooth surface: No wrinkles, scratches and bubbles

- High cleanliness: Production in no-dust workshop

FEP Release Film Installation Steps:

- Step 1: Remove screws at the bottom of the resin vat and take out the broken release film.

- Step 2: Then place the release film between two steel rims

- Step 3: Finally put the installed steel wheel back into the resin vat and tighten the screws

- To remove fingerprints, wipe the FEP Release Film with a lint-free cloth and isopropyl alcohol (IPA).

- NOTE： Be sure to remove the plastic protective cover on both sides of each sheet before mounting.

Screen Protector Specification:

- Materials: high-quality PET material

- Light Transmittance: 95%

- Thickness: 0.10mm

- Will not affect the 405nm wavelength of ultraviolet rays through the protective film and curing the resin.

Screen Protector Installation Steps:

- Step 1: Tear off the stained screen protector and clean the curing screen with a tool kit.

- Step 2: Wipe screen with alcohol prep pad.

- Step 3: Wipe the screen with a dry wipe.

- Step 4: Use a dust absorber to remove fine dust.

- Step 5: Peel off the back of the screen protector. Align the protector with the edge of the screen and stick it from one end to the other with a plastic scraper. Get the installation carefully without air bubbles.