The CNC automatic tool sensor gauge interfaces with the numerical control system to manage tool length calibration, detect tool wear, and identify tool breakage through programmed controls
The CNC tool setter features a normally closed design and comes with a cable, making it compatible with most CNC equipment
This automatic tool setting device features a stroke length of 5mm (0.2 in) and offers a repeat positioning accuracy of 0.001mm, with a force of 1.5N and a rating of DC24V at 20mA
The Z-axis tool touch sensor includes a magnetic base for direct attachment to the machine, ensuring a secure fit
Constructed from cemented carbide, this Z-axis touch tool setter offers resistance to wear and hardness
SPECIFICATION
-Voltage: DC 24V
-Current: Max. 20MA
-Stroke: 5mm / 02in
-Contact Force: 1.5N
-Repeat Positioning Accuracy: 0.001mm
-Tool Head Diameter: Approx 20mm / 08in
-Working Temperature: 0‑80℃
-Output Mode: NC (Normally Closed)
-Material: Aluminum Alloy
-Tool Head Material: Carbide Alloy
-Life: 3 million times
Note
Please control the tool setting speed at 50‑200mm/min and voltage at DC24V and the current below 20MA
Installation
Install it in the place where there are less iron chips and splashing water on the working table.
It must be installed vertically to avoid precision errors.
Before installation, be sure to disconnect the power first.
The bending radius of the wires should be above R7.
Protective tubes are recommended and the minimum bending radius with protection tube is R25.
PACKAGE:
1*Tool Setter