Are you still worried about the time-consuming preheating of 3D printing, poor material adhesion, and many printing failures? Try our GECO plate, which is tailor-made for PLA materials and a new printing experience will start immediately! No Heating to preheat the hot bed, only 1°C micro-temperature is required, which saves energy and electricity, and the printing cost plummets. It is a must-have for agricultural printing enthusiasts! Whether you are a novice or an expert, the first layer has super strong adhesion, and it is sticky at room temperature above 0°C. No glue spray is required, and the printing process is simplified. What's more surprising is that it is thicker and more durable than ordinary PEI hot beds, magnetic anti-warping, double-sided design, flexible disassembly, and spring steel plate for easy mold removal, and the printing experience is fully upgraded! Note: Although it is advertised as "no heating", it is recommended to increase the temperature to 20-40°C in low temperature environments (below 20°C). For large or batch printing, you can add a brim or increase the temperature. Daily maintenance is super simple: alcohol or soapy water can be wiped clean, and after long-term use, 55°C heat treatment can restore the stickiness to its original state. Compatible with many popular models of Bambu Lab (X1/X1C/X1E/P1P/P1S/A1), 257x257mm platform is perfectly adapted, sci-fi texture surface, the bottom of the print is exquisite and uniform, beauty and strength coexist! GECO board makes every print a pleasure!