This is a 3d Printed Made In The USA Rack Mounting Ears made by The Analog Source, This Item Fits The Behringer 80hp Series Neutron , K-2 , Pro 1 , Pro 800 , Kobol , Toro synthesizers, Note this is just a stand and does "NOT" include any music instrument (FEATURES) Made in the USA by The Analog Source, Note this item is custom made and is "NOT" a BEHRINGER product, Manufacturing process: 3D Printing, Material: PLA, Color: Black, Only fits the Behringer 80 hp series Neutron, K-2, Pro-1, Pro-800, Kobol, Toro synthesizer. On the Pro-800 you will need to remove a few screws and detach the wood side panels in order to install these rack ears otherwise it may be too long to fit on some racks. Designed by musicians for musicians ! Allows you to mount your Behringer synth onto a standard 19 inch wide studio rack. Take up 3U rack space. Reinforced with an angular support. Installation requires that you remove the side screws that attach the wood end panels to your synth. You then re-use the screws to attach the rack ears to your Behringer synth. Note that the wood end panels will remain in place. The rack ears will attach on the outside of the wood panels ! Note that mounting screws for attaching to your studio rack are NOT included ! Note that due to the nature of 3D printing and filaments, there may be a slight variation in color from that shown in the image. Also note that due to the nature of the 3D printing process, there will be some layer lines or other manufacturing details present in the finish. The listing image is a good representation of what you can an expect.