controller
DKD LCD Speedometer Display Adjustable ONE-LIN/CAN-BUS Communication For Fardriver Controller
NOTICE:
This display can be used in ONE-LIN and CAN BUS it can ONLY match with EM controller and Fardriver Controller other controller cannot match well pls note.
Please read the display function introduction in the details page carefully or contact the sales directly if you are not sure thank you! And pls make sure the battery is turned off when you connect or disconnect display otherwise it may damage the display.
Kindly note: the background color of the screen of this display is dark green the photo shooting may have color difference due to light please refer to the actual product.
- Package Including -
1pc x DKD LCD speedometer 48v-96v
1pc x sprokect
1) After power on the self-test of the display is completed then press and hold the left button for 10 seconds to enter the background and enter the password;
2) Left-click to adjust data right-click to shift;
3) Password 153 set the perimeter(mm) the number of motor pole pairs the offset the unit mm is CC 1413mm (18inch tire perimeter) by default after the setting is completed long press the right button to enter the number of motor pole pairs(PL 24-10 pole pair number 24 by default) and offset(10);
4) Password 256 high and low gear (E S gear) and normal gear selection -2 is high and low gear -0 is normal gear display;
5) Password 372 clear ODO limited to 3 times;
6) Password 856 48V 60V 72V 96V for selection synchronized with the grid number the lithium battery automatically takes the SOC and automatically switches. If the lithium battery is changed to the other battery and it must be powered on again;
7) Password 879 fixed voltage calibration 48V 60V 72V 96V corresponding to the volatge setting;
8) Password 824 self-input voltage calibration;
9) Password 974 KMH/MPH switch setting;
10) Password 928 D gear lig