Application
This product can be used to repair dents on steel car bodies. It is suitable for garages, or personal use.

How to Use
1. Move the heating head around the dent and check the changes. gradually move into the dent center.
2. Press the button at each heating spot for1-2 times.
3. After the previous processes are done, a dent will be reduced less than the heating head, put the heating head above the dent and heat again, but using less power or heating time.
4. Put the heating head near the dent and heat again several times.

Specification
Product Material: Iron, Plastic
Case Material: Al-alloy
Input Power: 110V-120V
Input Frequency: 50/60Hz
Output Power: 1.38KW
Output Frequency: 150KHz
Power Output Cable: 1.53m/5ft
Product Size: 13.5*25*7.5cm/5.3*19.84*2.95inch
Case Size: 31*32.5*16 cm/12.2*12.8*6.3inch
Package Size: 32*32*16cm/12.6*12.66.3inch
Gross Weight: 4kg/8.82lbs

Package Included
1 x Induction Heater
1 x Cable
1 x Power Cord
5 x Candles
1 x Hammer
1 x Suitcase
1 x English Manual
All Accessories for Use

Notes
1. To avoid causing damage to surface painting, do not apply heating on a single dent for a long time.
2. After 3-5 times heating, use a wet towel to reduce surface temperature.
3. Do not let the heating head touch the surface painting, leave a gap of 3-5mm.
4. During the heating process, the painting surface becomes soft, applying pressure on the surface will increase the dent.
5. Please read the model of this product carefully and make sure it fits your model before buying. Please understand that we will not accept a return request because of this.