1. High speed: Accepting a 32 -bit high speed chip, for the STM32F407 Microprocessor, with a main frequency to 168 MHz and an arithmetic unit with FPU floating, it guarantees a powerful data processing and speed.
2. Optimized thermal dissipation: The motherboard of the printer takes on a 2 -bearer card with an optimized thermal dissipation treatment and uses a MOSFET tube to guarantee a better thermal dissipation effect of the motherboard.
3. Stable power chip: thanks to a special power ship, a 12 to 24 V power input supports, the current from the hot bed can be reduced to 1/4 under the same power of the system, which effectively dissolves the problem of heating the moss tube in the warm bed.
4. High security: Protected protection against flooding, overloads, overheating and a pre-super-rush, the heating switch is automatically switched off to guarantee the safety of the printer's motherboard.
5. Offline upgrade function: supports the offline upgrade function, copy the upgrade file on the small memory card (not included) and then add it to the 3D printer to complete the program -upgrade.
6. Stable engine processing: The printer's motherboard has an integrated A4988 engine drive, with low resonance, subdivision of 256 Micropas, to operate the engine with step by step without mold or offset.
Specificationsification:
Type: printer motherboard
Size: approx. 130 x 100 mm / 5.1 x 3.9 inches
Microprocessor: for STM32F407
Input voltage: 8-35 V
Motor pilot: for A4988
Sensor type: Thermistor 100 K
Firmware update: supports a small memory card, you (not included) disk
Sketch Management Method, Online
Method of: Return out of tension:
Material Rupture Detection:
In use:
Install and use directly
List of packages:
Package consisting of 1 x printer motherboard