Mr. Mark Setter is an adhesive component, which gives decals greater adhesion to plastic parts. It is much easier to affix decals to plastic model part where the parts either have a rough or irregular surface. First, the area to which the decal will be affixed is painted and then the decal is applied. After any air bubbles are removed by pressing on the decal with a cotton swab, a coating of Mr. Mark Setter is applied and allowed to dry. Because the decal now has a greater degree of adhesion, adhesive silvering (the floating and shiny quality of the clear parts of decals) will be greatly reduced or eliminated, and decals can be firmly affixed to uneven surfaces. It is perfect even for poorly made decals. Decals will have greater adhesion if the painted surface is prepared with a gloss finish. Mr. Mark Softer is a softening agent designed to be used with decals (slidemarks). It enables decals to conform to rough and curved surfaces. How To Use Mr. Mark Softer First, apply a small drop of Mr. Mark Softer to the area where the decal will go using the brush attached to the bottle cap. Apply the decal over this area. Apply gentle pressure to the decal with a soft cloth, removing any excessive liquid and ensuring that the decal down fast. The decal will stick perfectly, even on uneven or curved surfaces. If air bubbles do get in between the decal and the model surface, allow the decal to dry, and then carefully prick the decal with a needle and insert Mr. Mark Softer through the resulting hole. The air will escape, and the decal will then stick down conforming to the surface of the plastic part.