Specification:
Name: 1500W step up constant current module
Type: Non‑isolated step‑up module (BOOST)
Input Voltage: DC10V to 60V
Input Current: 10V‑30V input voltage, maximum current is 35A‑40A; 31‑60V input voltage, maximum current is 30A‑35A
Quiescent Current: 15mA(when convert 12V to 20V, higher output voltage will increase quiescent current)
Output Voltage: 12‑97V continuously adjustable (cannot be used to step down voltage)
Output Current: 22A (related to the input and output voltage difference, the greater voltage difference is, the smaller output current will be. please enhance heat dissipation when current is over 15A)
Constant Current Range: 0.8‑22A(+/‑0.3A)
Reverse Input Protection: Yes (150A power MOS reverse protection)
Input Low Voltage Protection: Yes (10V‑50V adjustable, self‑recovery)
Operating Temperature: ‑40℃ to 85℃(if temperature is too high, please enhance heat dissipation)
Frequency: 150KHz

Note:
Please note that the fan of this product will be sent randomly, and make sure you will not mind before ordering.

Instructions:
Module output should not short circuit or measure current directly with multimeter short circuit, short circuit will burn out module.
Under voltage adjustable range:DC10V‑50V (clockwise to increase, counterclockwise to reduce), firstly adjust under‑voltage to the minimum, then adjust input voltage to required under‑voltage protection value, slowly adjust under‑voltage value clockwise to increase; when the under‑voltage light is on, adjust counterclockwise of one circle, then power on again.
Input under‑voltage protection mainly used to prevent battery from over‑discharging when input power source is battery. Low battery voltage will damage power module and battery. When input is switching power supply, it also need to set the low voltage protection.