Applicable to ATX architecture computers with POWER and RESET reboot switches.
The touch switch is suitable for the POWER button of the computer's power supply and the RESET restart switch, among other functions. One end is inserted into the POWER port on the motherboard, and the other end of the switch is connected to the computer case panel.

Usage:
1.Insert the labeled POWER connector into the corresponding pin on the motherboard.
2.Connect the switch connector to the front panel of the computer case to start using it.
After prolonged use of the computer case, the power and reset buttons may malfunction, causing startup failures and repeated restarts.

Both the power and reset buttons use a cable with a total length of approximately 68cm/26in.

In some cases, it may be necessary to disassemble the case in order to replace the cable. If you are not familiar with the process, please seek the help of a professional to avoid causing unnecessary damage.

The front panel switch cable for the computer case has four groups of wires with LED indicators. The wires can be separated by tearing them apart. The power switch and reset switch are interchangeable.

There are one group each for the power LED, HDD LED, reset switch, and power switch, with each wire labeled accordingly.
The computer's power LED indicates the status of the power supply, while the HDD LED indicates the status of the hard drive. The reset switch can be used to restart or reset the computer, and the power switch is used to turn the computer on or off.

Package includes:
5-PACK power switch cables
10pcs cable tie