All electronics ship with US style plugs.You may need a voltage converter or a plug adapter.
Special Features
[Powerful Power] The two-stroke engine with high power (1200W) and large displacement (32.6CC) and enlarged thick-walled cylinder enables high impact frequency (3200min-1) and impact energy (30J) to easily and quickly penetrate concrete, bricks, rocks, etc. at high speed (5000rpm).
[High Quality Material] The lacquered aluminum material is glossy and resistant to wear and high temperatures. Also, the plastic material is impact and deformation resistant.
[Low Consumption Rate] The built-in air filter can well filter the impurities in gasoline to reduce the consumption of the engine and prolong its service life; the built-in carburetor can fully atomize the fuel to reduce its consumption rate and save cost.
[Three-in-one Function] The concrete crusher is equipped with three drill bits and two different chisels, which can be used for hammering, drilling, or by adjusting the knob on the side to meet your diversified needs.
[Easy To Use] The cordless design and light weight of the chisel allows for increased flexibility in operation. The machine can be started by pulling the rope. In addition, the one-touch flame out switch and non-slip auxiliary handle are easy to use.
Description
Specification
Color: Black
Material: Aluminum, Plastic
Style: Modern
Surface Treatment: Painted Process
Assembly Required: Yes
Power: 1200W
Displacement: 32.6CC
Engine Type: Single Cylinder, Air Cooling, 2-stroke
Impact Frequency: 3200min-1
Impact Energy: 30J
Max Torque and Speed: 1.5N.m/5000rpm
Fuel Mixture Ratio: 25:1 (Gasoline: Motor Oil)
Fuel Tank Capacity: 0.9L/0.2gal/30Oz
Fuel Consumption Rate: ≤0.5L/0.1gal/16Oz Per Hour
Max Drilling Diameter: 40mm/1.5inch
Starter System: Hand Pull Start
Noise: ≤104dB
Net Weight (Exclude Drill): About 10.5kg/23lbs
Product Size (L*H): 63*24cm/24*9inch
Engine Size: 36*32mm/14*12inch
Drill Size: 22*350mm/0.8*13inch
Point Chisel Size: 18*350mm/0.7*13inch
Flat Chisel Size: 16*280mm/6*11inch
Auxiliary Handle Length: 13cm/5inch
Package Included
1* Hammer Drilling Machine
3* Drills
1* Point Chisel
1* Flat Chisel
1* Fuel Tank
1* Funnel
Other Accessories for Assembly
Notes
1.Before each use, please check whether the oil bubble is full of oil. If the oil is not enough, you need to press the carburetor until the oil is full. It is best to press the carburetor every time you use it. Please replace the air filter sponge after 36 hours of continuous operation to avoid damage to the engine cylinder.
2.Please clean up the oil in the carburetor if it is not used for a long time. The carburetor does not need to be replaced if it can be used normally.
3.Please add lubricating oil regularly to ensure strong power.
4.Please do not touch the muffler exhaust hole to avoid scalding.