Vacuum Solenoid Switching Valve
Replacement Part Number:90910-TC001, 90910TC001, 136200-7010, 1362007010, 911394, 2M1310, 90910-12276,9091012276
Package list:1pcs 90910-12276 Vapor Canister Purge Valve Solenoid
The steps to replace the carbon canister solenoid valve are as follows:
Position the carbon canister solenoid valve. The carbon canister solenoid valve is usually located on the side or bottom of the engine compartment, and the specific location can be determined by consulting the vehicle maintenance manual.
Disconnect the negative terminal of the battery. Before replacing the solenoid valve, for safety reasons, it is necessary to first disconnect the negative pole of the battery to avoid a short circuit.then remove the old solenoid valve from the vehicle.
Install a new solenoid valve. install the new solenoid valve in its original position and tighten the connecting pipes and fixing screws. Be careful not to tighten too tightly to avoid damaging the solenoid valve.
Reconnect the negative terminal of the battery. Reconnect the negative terminal of the battery, then start the engine and check if the solenoid valve is working properly.After replacing the carbon canister solenoid valve, a comprehensive inspection of the vehicle is required to ensure that there are no other faults. lf the fuel consumption of the vehicle suddenly significantly increases, it may be caused by multiple factors, and the carbon canister solenoid valve is just one of them.
Replacing the carbon canister solenoid valve requires certain operational knowledge and tools. lf you lack experience or are unsure how to operate it, it is recommended to seek the help of professional maintenance personnel.