Package Included:
1 Roll Rainbow window Privacy Film
1 Instruction for Installation
1 Knife and Scraper inside the packaging barrel
Installation instructions
1.clean the surface of wherever you are intending to place the product so it's free from dust, pet hair etc
2.cut the product 1” larger than the area you are covering - makes it easier to place and trim when it's installed
3.the product has a rough and a smooth side. The smooth side has a clear backing tape which you need to remove. The backing tape comes off very easily. Remove all of the backing tape
4.spray the side of the product where you have removed the backing tape from AND where you want to place the product with water
5.put the wet side of the product on to the area where you want to place the product (which is also wet)
6. grab your squeegee or Scraper and going from the center to the outside edge, smooth out air bubbles.
7. once you've got rid of the air bubbles, grab a knife and while holding the squeegee at the outside edge as a bit of a guide and to hold the product in place, trim all the edges. Make sure your blade is sharp and it should be quick to go all the way round.
8.Wipe clean the surface of the installed window film. And you are well done!