High-quality, "build-your-own" cable kit suitable for generally any motorcycle throttle application with a push-pull style throttle.
The ends of the inner wires are fitted with a 6mm dia x 5mm nipple. The opposite end will need to be cut to length and the required nipple soldered into place.
PLEASE NOTE: We strongly discourage the use of a propane type torch to heat and flow solder into the wire. This is likely to overheat the wire, causing it to become brittle. We recommend dipping the wire ends in a solder bath, such as that in a solder pot.
The ferrules are a snug fit. They may be bonded into place, or use a center punch to make a small indention in the side.
The throttle kit includes:
2 x 1.35 meters (4.4 feet/54.8 inches) of 6mm OD black PVC coated, spiral wound, Teflon lined outer conduit
2 x 2 meters (6.5 feet/78 inches) of 1.5mm OD galvanized steel wire (7 x 7 strand)
1 2-piece plastic angled wire guide
1 ferrule bend with swivel nut, throttle open, "Honda"
1 ferrule bend with swivel nut, throttle close, "Honda"
1 ferrule bend with mounting tab, throttle open, "Suzuki"
1 ferrule bend with swivel nut, throttle close, "Suzuki"
2 ferrule bends, zinc coated
2 ferrules, 5mm OD nose
2 ferrules, 6.5mm OD nose
2 ferrules, 5.5mm OD nose with groove
2 6mm x 1.00 x 25mm adjusters
1 tapered double boot
4 adjuster boots
2 brass barrel nipples, 6mm DIA x 10mm (2.1mm bore)
2 brass barrel nipples, 6mm DIA x 8mm (2.1mm bore)
2 solderless barrel nipples, 6mm DIA x 8mm
2 solderless barrel nipples, 5mm DIA x 7.5mm
2 tab washers