Replacement Parts: PPR150,PPR200,PPR300,PPR400
Applies To: 04524,04525,04526,04527

Instruction:
1,Cut damaged pipe as close to fitting as possible.
2,Select proper size fitting borer,put it in drill chuck,and tigh then.A standard 1/2" right angle drill is recommended.
3,Insert fitting reamer into broken pipe,ensure tool stays on center to prevent binding.If no chips are being made,remove tool and check.
4,Ream old pipe until proper depth is attained.
5,Remove drill and clean out chips from fitting.

Installation:
1. Inserted the shaft into the Body.
2. Make sure shaft was all the way through and flush with the bottom of the reamer.
3. Tightened and locked the screw through a 1/8”Allen wrench.

Rotate Carbide Insert:

Carbide insert has four cutting edges.Change cutting edge by removing the cap screw and rotating the carbide 180° then reinsert cap screw and tighten.Replace carbide as needed.

Note:
These reamers can be used with standard drills,cordless drills,or impact drills.For most effective use,run the drill at a low or medium RPM. Warning:
3" and 4" fitting reamers create a large reaction torque that can cause injury to operator,therefore a standard 1/2" right angle drill is recommended.Use caution when using these tools. For reaming 3" or 4",a lower RPM is recommended to reduce heat and possible distortion of the fitting.

Package Include:PPR150, PPR200, PPR300, PPR400 4 sizes.