Metallor Push Pull Pot DPDT Switched Guitar Bass Potentiometer Audio Volume Tone Split Shaft Control Switch 18mm with Nuts and Washers Guitar Parts Replacement (A250K)

Special Features

A250K-ohm logarithmic taper potentiometer with Double Pole Double Throw ( DPDT on-on ) push / pull switch. 6mm splined shaft to accept standard push on control knobs.
This switched pot is suited to being used in place of the standard tone pot, although it is personal choice whether you use these taper pots for volume or tone, on a single coil equipped guitar to provide tonal switching options. Typical uses include phase reversal, tone capacitor switching, tone bypass etc.
Shaft length: Approx. 18mm shaft diameter: Approx. 6mm Whole length: Approx. 45mm Base diameter: Approx. 22mm
Full size; Coarse knurled split shaft fits most control knobs
Package included: 1pc potentiometer, Supplied with 2 x mounting nuts and 1 washer.

Description

250K VS 500K

Generally, 500K-ohm pots are used with humbuckers and 250Ks are used with single-coil pickups. You can use any value you like, but a 250K will give a slightly warmer tone than a 500K pot. The 250K pot bleeds off some of the high frequencies to ground. A 1 Meg-ohm pot bleeds off even less than a 500K pot, so if you want to hear your guitar "wide open" you may want to try one.

PRODUCT DESCRIPTION

For bass guitar mainly

Push pull switch pots

A250k resistance

A type tone style

Approx. 18mm long shaft

Full resistance: 250k ohm

Shaft Diameter: Approx. 6mm

Whole length: Approx. 45mm

Base size: Approx. 22mm

Knurled and split shaft

PACKAGE INCLUDED