Overview
ESP32-S3 7inch Capacitive Touch Display Development Board, ESP32 With Display, 800×480, 5-Point Touch, 32-Bit LX7 Dual-Core Processor, Up To 240MHz
Frequency, Supports WiFi & Bluetooth, With Onboard Antenna

Introduction
The ESP32-S3-Touch-LCD-7 is a low-cost, high-performance microcontroller development board designed by Waveshare. It features 2.4GHz WiFi and BLE 5,
integrates large Flash storage and PSRAM, and a 7-inch capacitive touch LCD screen. Support running GUI interface demos such as LVGL. It also has
multiple external peripheral interfaces (such as CAN, I2C, RS485, and Sensor) for developing applications such HMI on ESP32-S3. With various
functions and interfaces, it is suitable for power requirements in IoT, mobile devices, wearable electronics, and smart home applications.

Package Content
ESP32-S3-Touch-LCD-7 x1
HY2.0 2P to 2PIN male cable 10cm ×2
HY2.0 2P to 3PIN male cable 10cm ×1
HY2.0 2P to 4PIN male cable 10cm ×2

FAQ
1.ESP32-S3-Touch-LCD-7 CAN reception failure?
① Restart the COM port in UCANV2.0.exe and press the ESP32-S3-Touch-LCD-7 reset button multiple times.
② Uncheck DTR and RTS in the serial port debugging assistant.

2.ESP32-S3-Touch-LCD-7 shows no response after uploading an Arduino demo for RGB screen displaying?
If there's no screen response after programming the code, check whether the correct configurations are set in Arduino IDE -> Tools: Choose the corresponding
Flash (8MB) and enable PSRAM (8MB OPI).

3.ESP32-S3-Touch-LCD-7 fails to compile an Arduino demo for the RGB screen and shows errors?
Check if the ESP32-S3-Touch-LCD-7_libraries is installed. Please refer to installation steps.