Winscon Electroncis - Relay Module Parameters:

Winscon Relay Module Board Description:
1, The module uses genuine high-quality relay, the maximum load of the normally open interface: AC 250V/10A, DC 30V/10A;
2, Using patch optocoupler isolation, strong driving ability, stable performance; trigger current 5mA;
3, The module working voltage is available in 5V, 12V (Please check the product page or Winscon Storefront Page);
4. The module can be triggered by a jumper to set a high level or a low level;
5, Fault-tolerant design, even if the control line is broken, the relay will remain stable will not operate;
6, power indicator (green), relay status indicator (red);
7, The interface design is user-friendly, all interfaces can be directly connected through the terminal block, very convenient;
8, Module size: Please refer to picture parameters;
9, Come with 4 fixing bolt holes, hole 3.1mm, spacing 44.5mm*20.5mm.

Two Module Interface:
1. DC+: Connect the positive pole of the power supply (the voltage is selected according to the relay, and there are 5V, 12V and 24V options)
2, DC-: connected to the negative pole of the power supply
3, IN: can control the relay to pull high or low

Relay Output:
1. NO: The relay normally open interface, the relay is suspended before the suction, and the short is connected with COM after the suction.
2. COM: relay common interface.
3. NC: The relay normally closes the interface, and the relay is shorted to COM before the suction is closed.

High and Low Trigger Selection:
1. When the jumper is shorted to LOW, it is triggered by low level;
2. When the jumper is shorted to high, it is triggered by a high level.