ADJUSTMENT STEPS:
1）Chain Adjusting Screw In The Chain Saw's Active Machine Rotation Shaft Behind, There Is An Adjusting Screw Between The Chain And The Bearing, Screwdriver Screw Clockwise Is Tight, Counterclockwise Is Loose.
2）Adjust The Tightness Of The Dowel At The Same Time, Check The Tightness Of The Chain, The Tension Is Appropriate When The Chain Is Hung In The Lower Part Of The Guide Plate, You Can Pull The Chain By Hand.
3）After Adjusting The Chain Tightening Screws, Tighten The Two Fixing Screws To Prevent The Chain Tightening Screws From Loosening. It Is Possible That The Chain Is Extended By Using It For a Long Time, And Cut Off a Section Of Teeth. If There Is No Adjustment Wire, Tighten The Guide Plate And Then Press The Offset Cover.