Note:
Motors of 550 or 5 series or above that are particularly tight do not support remove, otherwise the remover tool will deform. Thank you!

Instructions:
1. Select the appropriate needle based on the motor shaft diameter. Do not use a needle that is too small with a motor shaft that has a larger diameter, as this may cause the needle to break. If the gear has adhesive, it should be heated first to melt the adhesive before removing the gears. >
2. Choose the desired tooth puller needle and install it onto the tooth puller rotating rod. Tighten the screw (Note: for needles with a platform, the screw should not be tightened too much). >
3. Attach the tooth puller rotating rod to the tooth puller bracket. >
4. Install the tooth puller movable plate. >
5. Mount the motor onto the tooth puller movable plate, aligning the motor shaft with the tooth puller needle. >
6. Rotate the tooth puller rotating rod clockwise at a constant speed to pull out the motor gear. >
7. You can remove gears with a maximum outer diameter of 11mm and a tooth height of up to 12mm. >
>