Universal Truck Bed Flag Mount - No Drilling Required for Easy Installation - Holds up to 1.25" Flag Pole - Works with bed rail and non bed rail equipped vehicles - Made from 3/16 plate steel and .120 wall tubing for extreme durability - Powder Coated Textured Black to match your lined truck bed - Can be mounted in multiple positions in the truck bed (depending on make/model) - Comes with all hardware required for installation. Install Instructions: 1. Remove your truck Bed Flag holder from the packaging and determine whether or not your vehicle has bed rails. Bed rails are shown below. If you truck is equipped with bed rails skip to step 6. If no bed rails are present continue to step 2. 2. Position your flag mount on the bed side making sure there is a flat spot present under your bed side for the mounting brackets to attach. 3. Install the mounting brackets under the bed side, ensuring the are located on a flat spot on the under side of the bed side like shown below. 4. Install the flat washer, lock washer, the nut to the mounting bracket. Using a 13mm open end wrench or deep socket, tighten the mounting bracket until the flag mount is secure. Continue to Step 7. 5. If your truck has bed rails, slide the provided 1” sliders into your bed rails and locate in the desired flag mount position. 6. Now position the flag mount over the bed rail nut studs and install the flat washer, lock washer, and nuts. Torque with a 13mm open-end wrench or deep socket until the flag mount is secure. 7. You may now install your flag pole and tighten in place with the supplied thumb screws. Tighten and check thumb screws regularly before use to ensure the flag is secure. You flag mount is now fully installed and ready to use!