Jengu 100W Aquarium Heater — Made for the M1 Smart Tank
Ever used a generic heater? Suction cups that lose grip, glass tubes floating around, cords pushing the lid open. And the worst: forgetting to unplug during a water change and watching it dry-burn. This heater solves all of that — it's built exclusively for the Jengu M1.
Slides In and Stays Put
Forget suction cups. It slides directly into the M1's pre-built back chamber slot and sits flush — insert and plug in, that's it. The heating body stays fully submerged while the top controls stay safely above water. No exposed glass, no daily adjusting.
Two Safety Systems, Total Peace of Mind
A flow sensor cuts power instantly when water drops below the minimum line during a change, preventing dry burn and cracked glass. If water exceeds 96°F, overheat protection shuts down and won't restart until it cools. A full-length guard protects your hands and chamber walls from heat.
Set the Exact Temperature Your Fish Need
Press once to raise by 1°F, or hold to scroll through 64-94°F — the range where bettas, guppies, and tetras thrive. The heater shows your set temperature; the M1 shows actual water temp. A 1.8-5.4°F gap is normal during heat transfer. Warm-up is gradual so it never shocks your fish.
100W for Warm Fish All Winter
Cold nights make room temperatures dip, and that's when tropical fish get stressed. 100 watts is perfectly sized for the M1's 5-gallon volume — it holds steady even on the coldest nights, so your fish stay active and healthy.
What's Included
1 Jengu 100W Digital Heater with integrated guard, pre-fitted for M1 Smart Tank, plus a quick-start guide. Important: the top display is not waterproof — keep it above water at all times. Error code or protection mode? Contact Jengu support — we're here 24/7.
