Radiolink Byme-D is a 3-axis gyro flight controller for RC delta wings, flying wings and paper planes that use mixed elevator and aileron control.
Three flight modes
Stabilize mode: the flight controller helps balance the aircraft and levels it when the sticks center, with roll limited to 70 degrees and pitch to 45 degrees.
Gyro mode: the 3-axis gyro assists stability while the aircraft does not level itself.
Manual mode: no flight controller algorithm and no gyro input, all movement comes from your sticks.
Setup
1. Mount it near the center of gravity, with the arrow pointing to the nose.
2. Wire CH1 to the left servo, CH2 to the right servo, CH3 to throttle, and the receiver to the SBUS/PPM port.
3. In the radio, set CH3 throttle to reverse and leave all other channels normal, and set no mixing on the transmitter.
4. Power on and keep the model still until the green LED turns solid.
5. Hold both sticks at the lower outer corners for more than 3 seconds until the LED flashes once.
Before you order
Receiver: a receiver with SBUS or PPM serial output is required.
Radio: 7 channels or more, a 3-position switch on CH5 for flight modes and a 2-position switch on CH7 for motor lock.
Power: input 5-6V. If your ESC has no BEC, add a separate BEC.
Airframe: for mixed elevator and aileron models only. Not for V-tail models.
Stabilizer only: no GPS, no return to home and no altitude hold.
Specifications
Size 35.5 x 15.5 x 10.5 mm, weight 4.5 g with wires, 3 channels, input voltage 5-6V, working current 25 mA (±2), three-axis gyroscope and three-axis acceleration sensor, SBUS/PPM signal.
Package list
Byme-D flight controller, receiver connection cable, double-sided adhesive tape, packing bag.