36V/48V/60V 12-40A brushless sine wave controller:

1.phase wires
2.electric door lock（key lock）
3.reverse
4.cruise
5.jog three-speed gear
6.3-speed
7.PAS
8.single and dual drive switch
9.throttle
10.hall meter
11.hall wires（5wires）
12.low brake
13.Intelligent recognition（self-learning line）
14.high brake
15.phase meter
16.Multi data instrument meter

How to connect controller？

1.connect the motor phase line(color to color）
2. connect the hall line,color to color connect.(if motor without hall line, don't need connect)
3. connect the battery line(red:battery+ , black:battery-)
4.off power,let two intelligent recognition lines connect together,open power,then the wheel will forward or reverse.
(1.if wheel forward ,Separate the intelligent recognition line.
2.if wheel reverse, Separate the intelligent recognition line. Let intelligent recognition line connect together again,if wheel forward ,Separate the intelligent recognition line.)
This step needs to be effective within 2 minutes after the power is turned on. If the timeout occurs, please turn off the power and then turn it back on before proceeding with these steps. 5. connect the controller throttle to throttle and need color to color connect, connect controller electric door lock to throttle electric door lock
（if throttle not have electric door lock,let controller electric door lock short,
so controller electric door must connect ）
NOTE:when use throttle control speed,two intelligent recognition line must separate.
6.single and dual drive switch：When these two wires are short circuited, the controller enters dual drive mode.
But when they are separated, the controller enters single drive mode.
7.other functions can be connected as needed.