Product Characteristics: This sensor is used to calculate air density and determine the engine's air mass flow rate and provides instantaneous manifold pressure information to the engine's electronic control unit.
Feature: Made of good quality material. It is stable and durable, use for a long time.
Installation: 1.Install: Remove old sensor; mount new in engine bay (passenger side). 2. Vacuum & Wiring: Connect to BOV source; route wires through firewall to door; link to power(note signal). 3. ECU: Plug into ports(see manual); ECU under p-side carpet.4.Bypass: Splice new power/ground to factory; insulate old signal; connect new to UTEC.5.Calibrate: In UTEC(Edit s>Params>Special), input intercept/gradient per manual's voltage/pressure. 6. Test: To drive and check loose/solder issues.
Car Idle Air Control Valve for Mazda Protege 1999-2003 Replace No.FSN520660B IACV Idle Motor Idle Air Control Valve for Stable Engine Operation
KWD 11
1 Set Oil Drain Plug for Mercedes-Benz Sprinter 2500 3500 2010-2021 Engine Oil Pan Drain Bolt Screw Thread Repair with Gasket Silver Tone Steel
KWD 5.500
94460-2P000 Fuel Tank Float Gauge Sending Unit Fuel Level Sensor for Hyundai Santa Fe 2010+ for Kia Sorento 2009+ Replace Parts
KWD 6.500
2pcs Windshield Washer Nozzle for Toyota Tacoma 2016-2023 for Lexus RX350 2016-2022 Front Windshield Spray Nozzles Wiper Spray Washer Jet No.8538130220 Black Plastic
KWD 6.500
