Enhanced Durability: Constructed from CNC machined, hardened steel, this gear offers superior strength and longevity compared to factory plastic gears.
Added Protection: The black oxide finish adds an extra layer of protection against wear and corrosion, ensuring the longevity of your investment.
Precise Marking: The laser-etched tooth count marking provides easy identification and precise gear mesh adjustments, enhancing performance.
Easy Installation: The gear is conveniently designed for easy manual gear mesh adjustment without the need for pins, making installation quick and hassle-free.
Perfect Fit: With an overall diameter of 52.8mm and gear face width of 8mm, this gear is a perfect upgrade for the factory plastic 54T spur gear, ensuring a seamless fit with your vehicle.
وصف
Hot Racing 50 tooth hardened steel Mod 1 (1.0 metric pitch) spur gear for the TRA E Revo2, 6S and 8S, Maxx 4S, XO-1 XRT and Sand Car
FEATURES:
- CNC machined hardened steel construction
- Black oxide finished
- Laser etched tooth count marking
YOU WILL RECEIVE:
- One (1) 50T, 1 mod steel spur gear
REQUIREMENTS:
- Do NOT use the pin system for setting the gear mesh. Instead, manually set the gear mesh without the pins. Refer to the TRA manual for instructions (ref. pg.22 - Adjusting Gear Mesh)
- With the pins removed, use the four 4x16mm button-head cap screws on the bottom to set gear mesh. Loosen the four 4x16mm button-head cap screws. Cut a narrow strip of notebook paper and run it into the gear mesh. Slide the motor and pinion gear into the spur gear. Tighten the four 4x16mm button-head cap screws, and then remove the strip of paper. You should be able to run a fresh strip of paper through the gears without binding them.
SPECIFICATIONS:
- Overall diameter: 52.8mm
- Gear face width: 8mm
COMMENTS:
- Upgrade for factory plastic 6448 or 6448X 54T spur gear
