4-Piece Tape-On Window Visor Set for 2022 2023 2024 2025 Ford Maverick

This set of four window visors is custom-designed for the 2022 2023 2024 2025 Ford Maverick. Utilizing an outside-mount, adhesive tape installation method, they provide a functional upgrade without the need for permanent modification to your vehicle.

Product Details & Fitment

Compatibility: Designed exclusively for the 2022 2023 2024 2025 Ford Maverick.

Style & Mounting: Outside Mount (Tape-On). These visors adhere to the door frame above the window using included adhesive tape. They are not an in-channel style that fits inside the window groove.

Set Contents: 4 pieces total – covering both front and rear side windows for the driver and passenger sides.

Material: Constructed from black, reinforced acrylic.

Installation: Direct peel-and-stick application. No cutting or drilling is required.

Design Features & Purpose

Custom Contour Fit: Meticulously shaped to match the curvature of the Maverick's window frames, aiming for a low-profile, OEM-style appearance once installed.

Weather Protection: Designed to allow you to lower your windows slightly for ventilation during rain or hot weather, while helping to minimize water, dust, and wind from entering the cabin.

Sun & Heat Reduction: The tinted visors can help block a portion of direct sunlight and UV rays, which may assist in keeping the interior cooler and protecting surfaces from sun damage.

Driving Comfort: By smoothing airflow over the windows, these deflectors can help reduce wind noise and buffeting inside the vehicle when driving at higher speeds with the windows partially open.

Installation Instructions & Important Notes

Surface Preparation: This is the most critical step for a secure hold. Thoroughly clean the intended mounting area on the door frame with isopropyl alcohol to remove all wax, grease, and dirt. Ensure the surface is completely dry.

Dry Fit & Alignment: Before peeling off the adhesive backing, hold each visor in place to confirm the positioning and alignment.

Application: Peel off the protective liner from the adhesive tape and carefully press the visor into place, applying firm pressure along its entire length.

Curing Time: For the strongest bond, avoid washing the car or rolling down the windows for at least 24-48 hours after installation, especially in colder weather.

Note: Installation is easiest and adhesion is strongest when performed in moderate temperatures (ideally between 60°F and 85°F / 16°C and 29°C).

Package Includes

4 x Window Visor Deflectors (Front Pair & Rear Pair).

High-strength automotive adhesive tape pre-applied.

Instruction guide.