NYLON FUEL KIT Compatible With -2005 3.8L Only Nylon Fuel Line Replacement Kit Made in the USA Inline Tubes Nylon fuel repair kit is manufactured to substitute your original rusted out factory steel line in the rear of the car all the way to the front engine. From the gas tank line to the quick connect the engine.(refer to instruction guide for install) The new lines will run off the fuel tank line and charcoal canister to the front of the car. They will connect into the existing fuel fitting, Take off old and snap on new. For the vapor line cut existing nylon tube and connect with nylon blue black union. The existing lines rust from the back forward. The hard line can be rusty from the back to the front so this kit gives you the material to go the entire length so you never have to deal with this problem again. You can attach new lines into existing clips or zip tie to the old ones. Our kit is engineered for easy install, that does NOT require removal of the gas tank or original hard fuel line. This gives you the ability to not have to worry about dealing with the old rusty corroded fuel lines. Install the kit connect to the existing lines and you are done in 30 minutes. No Bending of metal lines, no flaring of tubes, Simple driveway fix have you car back up in 30 minutes. Why NYLON FUEL LINES? , Nylon fuel lines will not rust, rot or crack, Will resist salt, dirt, mud and other earth elements , Nylon kit fits right into the factory clip locations, Very flexible and easy to bend with clamps to properly place the new line , Nylon fuel line is rated @ PSI & °F, RATED PSI AND °F. TEMPERATURE