1PCS Hydrothermal Autoclave Reactor with PTFE Chamber Hydrothermal Synthesis 25-500ml
1.Technique Data:
(1) Operating temperature: 220°
(2) Working pressure: 3MPa (gauge)
(3) Heating, cooling rate: 5 c / min
(4) specification 25ml,50ml,100ml.
(150ml,200 ml or others customized according to users needs.)
The reaction means and the reactor body, and to ensure feeding coefficient is less than 0.8. When the Department of corrosive reaction when you want to put PTFE bush, can only be assured kettle body from corrosion. Hydrothermal synthesis reactor will be placed on the heater, in accordance with the provisions of the heating rate of heating to the desired reaction temperature (less than the required safety temperature). Completion of the reaction will be when its cool, but also in strict accordance with the provisions of the cooling rate operation, to facilitate the safety and reactor life. When confirmation of intra-abdominal temperature below the boiling point solvents reaction system can only open the tank lid after a follow-up operation.
Hydrothermal synthesis reactor each time after use to clean, to avoid corrosion.
Kettle body, kettle lid seal line to pay particular attention to clean and prevent damage to the bumps.
4.Introduction of "para-polyphenylene (PPL)" lining performance of hydrothermal reactor:

200ml hydrothermal reactor introduces product features:
1. High temperature resistance: use temperature -200 ~ +300 °C;
2. Low temperature resistance: -196 ° C can be maintained at 5%;

Size : 5-500ML
DIY Supplies : Electrical
Certification : None
Body material of the kettle : 304 stainless steel
Lining material : PTFE
Maximum pressure : 3MPA