For For Ni&nja 300 2013 - 2018
Installation:
Find the 4-pole male diagnostic connector(DLC), usually near the ECU box,It may have a removable cap and may be partially covered by black tape.
Set up:
-You need to setup the module after installation. When ignition is turned on, the display counts wards (6 to 1) indicating that the memory is clear.
-Raise the rear wheel off the ground by using a stand, and start the engine in Neutral. (If you do not have a stand, you may setup the unit while riding. Find a long, straight with light traffic.)
the screen displays L, indicating that learning is started.
accelerate through the handle throttle slowly
-The display will blink "1".Select first gear, release the clutch, and keep the RPM above idle speed. The display is blinking faster while the unit is learning the gear.
-When the display shows "2", select second gear.
Repeat this process until all gears are thought (5 or 6).
The unit is programmed and should indicate the gears correctly.
Now, when ignition is turned on, the display counts forward (1 to 6) indicating that it is fully functional.
If you have any questions, please feel to contact us, I will solve your problem as soon as possible.