Speed Control
42 57 Stepper Motor Drive Control Board Forward and Reverse Controller Limit Angle Pulse Speed Drive Module Programmable
Specification:
Product model: YF-31
Voltage range: 10~30V
Current range: within 4A
Delay time: 0.1~999S
Housing: special rail
Product size: 128mm*81mm*38mm
Function introduction:
P-1: point motion; Press and turn, touch the limit stop or release stop;
P-2: Self-locking: press forward to keep forward; Press inversion to hold inversion; Keep loosening; Hit the limit stop.
P--3: give forward signal; Stop X seconds after reaching limit 1; Automatic reverse to limit 2 stop.
(Summary: to signal; Motor from A to B; Then automatically from point B to point A end; Limit control.)
P-4: Power forward rotation; Stop X seconds after reaching limit 1; Automatic reversal to limit 2 after stopping X seconds; Automatic forward to...... Infinite cycle (summary: the motor cycles back and forth between two points A and B; Limit control.
P--5: give forward signal; Turn forward X Angle stop; Give a reversal signal; Reverse X Angle stop;
P-6: give forward signal; Turn forward X Angle stop; Delay T seconds; Auto reverse X Angle stop;
General: motor from A to B point; Then automatically from point B to point A end; Pulse control.
P-7: Power forward X Angle stop; Delay T seconds; Reverse X Angle stop; Delay T seconds; And turn X Angle stop; Infinite cycle.
(Summary: Cycle back and forth between two points A and B; Pulse number control.)
P--8: give forward signal; Turn forward X Angle stop; Delay T seconds; Turn forward X Angle stop; Infinite loop to reverse the signal; Reverse X Angle stop; Delay T seconds; Reverse X Angle stop; An infinite loop.
(Summary: Turn in a single direction; Stop for a moment; Infinite loop.)
Code potentiometer setting instructions:
Time adjustment: Press No. 1 encoder to enter the reverse and reverse intermittent setting mode, and rotate No. 2 encoder to adjust the speed value.
No.1 encoder: rotary potentiometer adjustable speed 0.1~999.9 RPM; Short press the encoder button; Can enter the function mode selection; Adjust the mode and stop operation for 2 seconds; Automatically exit Settings and save mode.
No.2 encoder: The number of adjustable pulses of rotating potentiometer is 1~99990. Short press the encoder button to enter the decimal point adjustment; The decimal point indicates that the unit is 10; No decimal point means in units of 1; For example, display :1600 indicates that 1600 pulses are set, that is, one circle; 160.0 indicates that the set is 16,000 pulses or ten turns.
Note:
1.Due to the light and screen difference, the item's color may be slightly different from the pictures.
2.Please allow 1-3cm differences due to manual measurement.
Package includes:
1x Stepper Motor Drive Control Board
==========