This Repair Kit is directed to people with basic knowledge in electronics. Repair is offering this repair kit for a common failure in SAMSUNG BN96-46947A BN96-49639A Power Supply Boards: DEAD TV / BLOWN FUSE ONE OR TWO BLUE CAPACITORS IN BAD SHAPE /USUALLY BLOWN Using same parts in our repair services. You will receive parts from the same pool that our technicians on site use and only the parts that commonly fail on these boards. Many of these are recommended replacements on the official Service Manual to correct factory installed parts. recommends to replace all parts at the same time even if they look ok. these parts tend to fail in different ways. FREE HEAT SINK COMPOUND ADDED WITH THIS PURCHASE. WHAT IS THE PURPOSE OF HEAT SINK COMPOUND? For electrical applications, heat sink compound is used to thermally bond a component with a mechanical heat sink. The compound is designed to efficiently transfer the heat from the heat generating component to the heat dissipating device. NOTE Because not all of the boards fail in the same way, we do not guarantee that the components in this kit is all you need to fix your board but it can take care 90% off all cases. It's your responsibility to troubleshoot and properly diagnose your board in order to complete the repair. It is important to note that the above described behavior can be caused by a number of very different failures and not all of them could be related to this repair kit ! We recommend all kits fitted by a qualified personnel. A successful repair depends on the own skill and fault finding ability. This service kit is intended for use by persons having electrical, electronic and mechanical experience and knowledge at level generally considered acceptable in the consumer electronics and appliance repair trade. DOING YOUR OWN REPAIR WORK: The removal and replacement/installation of electronic components at the circuit board level is NOT recommended if you are not experienced with electronic component and circuit board repair. If you are new to this stuff, please take our advice and leave the work to a qualified expert- you will most likely thank yourself later. It is VERY easy to cause damage to electrical parts and circuit boards if repairs are not done with precision, neatness, and accuracy. It is very easy for one to make problems WORSE than they were before, if one does not know what one is doing, or does not have adequate experience with these kinds of parts and this kind of work in general