The fog light trim Compatible with 2025 2026 Tesla Model Y Juniper. It is designed according to the original vehicle, and perfectly fits its body.

Installation Step:

Step1: Determine the installation location and then make comparison of the product and installation location.

Step2: Clean the surface where you want to stick. Keep dry and clean.

Step3: Remove the tape cover. No cutting or drilling required.

Step4: Align position and then paste. The paste effect depends on paste conditions and correct installation.

Step5: Please do press hard especially on the edges at least 2 mins after installing.

Step6: Please don't touch water and Keep dry after been install at least 48 hours. Or it will easy to fall off.

Installation Tips(Important):
Wipe clean the installation place, no water, dust, oil
If the temperature below 10℃(50℉), recommand using a hair drier to heat the tape to improve adhesive before install Tear off a little tail end tape film, compare the installation position, stick it slowly to the car, press firmly to complete the installation Please try not touch water after pasting within 48 hours