Ready to run kit includes black epoxy finished aluminum radiator and fan shroud, 16-inch fan, and mounting hardware. Fabricated aluminum end tanks with high-flow 3-row aluminum core design. Furnace brazed construction with TIG welded end tanks, no epoxy sealer or tank crimps/O-rings to fail. OE style black finish for a low-key stock appearance under hood. Available in three widths (28”, 31”, and 33”) to accommodate various core support openings. Dual pass cross flow radiator core to maximize coolant thermal transfer. Three rows of .790-inch core tubes for extra coolant capacity and more cooling fin contact. Approximate 17 percent increase in cooling system capacity over typical 2-row radiators. Radiators include integrated steam port and temperature sensor NPT thread fittings. Billet aluminum filler neck is stronger and seals better than cast filler necks. Features standard LS-spec 1.25” upper and 1.50” lower radiator hose fittings. Integral transmission cooler uses standard 1/2-20 inverted flare female (IFF) fittings. Keep Your LS Swap Build Cool Using Our Universal Fit Double Pass Aluminum Radiator Kit The LS engine has found its way under the hood of just about every make and model you can think of since it became the darling of the engine swap world. Compact, powerful, tons of upgrade and performance options, and most of all, easy on the wallet, the LS swap has become common place. The more interesting swaps require a little planning and fabrication to pull off a successful swap, but they quite often turn the most heads and are often the most talked about vehicles at a show. The thing is the LS cooling system can be a head scratcher for some. More so than fabricating a set of motor mounts even. The cooling system utilizes a surge tank setup and two or four steam port outlets from the cylinder heads