Product Characteristics: This MAP sensor is used to calculate air density and determine the engine's air mass flow rate and provides instantaneous manifold pressure information to the engine's electronic control unit.
Feature: Made of good quality material. It is stable and durable, use for a long time.
Installation: 1.Install: Remove old sensor; mount new in engine bay (passenger side).2.Vacuum & Wiring: Connect to BOV source; route wires through firewall to door; link to MAP power (note signal).3.ECU: Plug into ports (see manual); ECU under p-side carpet.4.Bypass: Splice new power/ground to factory; insulate old signal; connect new to UTEC.5.Calibrate: In UTEC (Edit Maps>Params>Special), input intercept/gradient per manual's voltage/pressure.6.Test: To drive and check loose/solder issues.
1 Pcs Car Engine Timing Cover Gasket Set for Volvo 3.0L 3.2L Chain Case Cover Gasket No.31251345/30711314 Silver Tone Metal
KWD 8.500
4WD Front Four Wheel Drive Actuator, 4x4 Front Differential Axle Actuator, for Chevy Silverado Avalanche K1500 K2500 K3500, ABS, 26060073, Black Replace Parts
KWD 16.500
1 Set CV Joint Boot Kit for Mitsubishi Outlander 2007-2020 Inner Constant Velocity Joint Boot W/Clamps No.3817A125 Black Rubber
KWD 6.500
Trunk Release Switch Gasket Liftgate Latch Cover Lid for Toyota Camry 2007 2008 2009 2010 2011 Replace Parts
KWD 4
