Application: This product is suitable for autoe spray paint room, local paint drying, putty drying, heater, printing dryer, various drying equipment, etc.
How to install:
1. Install two lights and secure their ends with 2 clips.
2. Place the net into the housing.
3. Fix the two brackets to both ends of the housing with screws.
4. Connect the wires at both ends of the lamp (right to right, left to left) and connect them to the neutral live conductor (make sure the hot wire is on one end and the neutral wire is on the other).
Specification
Color: Red
Material: galvanized sheet, iron
Process: high temperature spraying process
Volta: 110V, 50Hz
Heating area: about 1m³/35.3ft³
Total power: 2000W
Power of each heating tube: 1000W
Please allow slight color difference due to shooting light and 1-3 cm error due to manual measurement and make sure you do not mind before ordering.