مميزات خاصة

While a positive hook angle is great for ripping, a negative hook angle is better for crosscutting & finishing
The negative face of the tooth is much less likely to cause chipping in the surface of the wood as it's oriented in a counter-rotation direction.
This type of hook angle also provides an opportunity to better control your work, as the blade is much less likely to try and pull the wood through the saw or the saw blade through the wood (depending if you are talking about a table saw or a radial arm saw or sliding compound miter saw).
60-Tooth: 0.086“ thin Kerf, (-5°) Negative Hook Angle ATB Tooth, High tooth blades cuts with a clean, smooth, beautiful edge
Non-Stick Coating: Reduces friction and gumming, anti-rust, anti-overheat, easy to clean & store
Laser Cut Stabilizer Vents: Trap noise & vibration and stabilize the blade keeping it cool, reducing the blade warp
7-1/4" (185mm), 5/8" Arbor, 8,500 MAX.RPM, Diamond knockout arbor,

وصف

Negative 5-degree hook angles (-5°) : For Sliding Compound Miter Saw & Radial Arm Saw Polished Fine finish, Fine Cut, Framing, Crosscut wood, plywood, MDF, plastic, veneer, lumber, laminate, etc.
C3 tungsten carbide tipped tooth provides long lasting
Laser Cut Stabilizer Vents: Trap noise & vibration and stabilize the blade keeping it cool, reducing the blade warp
Non-Stick Coating: Reduces friction and gumming, anti-rust, anti-overheat, easy to clean & store
7-1/4" (185mm), 5/8" Arbor, 8,500 MAX.RPM, Diamond knockout arbor

مرحبًا،

بحث

شفرة منشار ميتري منزلقة مقاس 7-1/4 بوصة، زاوية خطاف -5 درجة، تشطيب ناعم 60T، طلاء غير لاصق، عمود 5/8 بوصة، ضربة قاضية ماسية

مميزات خاصة

وصف

منتجات شبيهه