مميزات خاصة

USB-C Fast Charging Trigger Module: Simply plug this module into a USB-C charger supporting PD fast charging to intelligently trigger multiple fast charging protocols including AFC, QC,PD. It perfectly supports rapid charging for laptops, mobile phones, and power banks. significantly boost charging efficiency and save valuable time!
Voltage Level Switching: The USB-C PD trigger board features a DIP switch (up = 0, down = 1). Simply align the correct switch position with the voltmeter to cycle through preset voltage levels (5V, 9V, 12V, 15V, 20V). This board enables rapid, convenient extraction of precise voltages from PD chargers without requiring bulky professional equipment.
Fast Charging Design: This product supporting multiple fast-charging protocols including AFC, QC2.0/3.0,PD 2.0/3.0. Simply connect a PD-compatible charger or power bank to transform it into a flexible, adjustable, high-power fast-charging power supply. It delivers the required voltage for powering drone-mounted equipment, Raspberry Pi devices, LED light arrays and similar applications.
Over-temperature and over-voltage protection: This USB-C PD trigger board incorporates over-temperature and over-voltage protection. Integrated chips continuously monitor operational status, safeguarding your valuable equipment from unexpected current surges. Enjoy worry-free charging.
Wide Compatibility: The USB-C interface is compatible with a wide range of devices. Simply connect a PD-compatible charger to the trigger board to power older or non-standard devices, or to repair and modify original chargers. It is suitable for any DIY project requiring a flexible, portable, and stable DC power supply.

وصف

Fast charge support protocol: PD2.0/PD3.0, QC2.0/QC3.0, AFC
Support voltage: 5V, 9V, 12V, 15V, 20V (voltage step is not supported)
Output voltage: Maximum 20V
Interface: Supports USB Type-C PD
Dimensions: 30*20mm
Weight: Approximately 3g
Packaging: 4 pieces per pack
NOTE:1.After Adjusting the DIP Switch,Since there is No Voltage Indicator, It is Recommended to Use a Multimeter to Measure the Voltage Before Connecting to the Application Circuit;
2.If the DIP switch is not adjusted according to the table behind it, the module will output any of 5V-20V the above voltages.
3.Before using the DIP switch, please remove the light yellow protective film.
4. The USB-C PD Trigger Board Module is solely a protocol trigger and not a voltage regulator. When operating at high voltages, it is recommended to combine it with a DC-DC buck converter module. This buck converter module shall provide a stable, controllable, and safe final output voltage.
Instructions for use:
S1 corresponds to DIP switch 1
S2 corresponds to DIP switch 2
S3 corresponds to DIP switch 3
Switching to the bottom is 0,Switching to the top is 1.
Toggle switch to request the appropriate voltage according to the charger protocol.

مرحبًا،

بحث

لوحة تشغيل RIIEYOCA 5V-20V USB-C PD، AFC QC PD 2.0 3.0 إلى Type-C لوحة طاقة للشحن السريع مناسبة لشحن الكمبيوتر المحمول، وبنوك الطاقة DIY، واختبار إمدادات الطاقة ومشروعات الإصلاح (4 عبوات)

مميزات خاصة

وصف

منتجات شبيهه