Flowmeter
Not offer battery. Thank you for understanding.
1.Keypad definition
Keypadfrom the left to the right, respectively, the keyset "SET", the keyplus "+", the key minus"-".
2.Display manual
1)Temperature:
The temperature range is -99 ° ~ 999 °, the unit C is the Celsius temperature, and F is the Fahrenheit temperature.
The temperature unit can be switched by pressing the "+" Up key.
2 ).Use time / flowratedisplay
whenno water flowing, show the total timeDAY(only in water pressure mode show timeDAY).
The total time unit DAY is days, HRS ishours, time units can press the "+" key to switch.
The flow rate unit LPM means "liters / minute", GPM stands for "gallons per minute", and can be switched by pressing the "-" key.
The current interface number is displayed under other interfaces: 00 indicates the K value setting interface (K SETING).
3) Power noted:
The power prompt icon will be displayed when the battery is low and flashing.Reminder the user to replace the battery.
In the case of adequate power it is not displayed.
4)Faucet animation (flowmeter only)
When detectedwater is flowing, the faucet animation will begin to show water droplets
5) Total water consumption, flow rate display
....................Flow sensor meter display controller................
6)(K SETTING)
K value setting characters will be displayed when entering the K value setting interface.
7)Total flow character (TOTAL) (flowmeter only)
When the system is operating in the flowmeter mode, the total flow character is displayed in the main interface.
3 .Settings and interface description
1)The main interface and settingsunderthe main interface
(1) The main interface will display the characters "TOTAL", total water consumption, temperature, total use time.
(2)Press the "SET" key in the main interface to set the total usingtime. Press the "SET" key on hold ,
the first number of time will flash, short press "+" flashing numbers will be added;
....................Flow sensor meter display controller................
2) K value setting interface and setting of K value setting interface (flow meter mode only)
.................Flow sensor meter display controller.......................
4 .Others
1 .System hibernation mechanism (flowmeter only)
.................Flow sensor meter display controller......................
2 .Total water consumption is reset
There is a RESET symbol on the back of the board, with two contacts next to it. After the system is powered on,
the two contacts will clear the total water consumption.
==========
Joint Pipe Bore Size : 1/2"
Coupling Type : Male BSPP Thread
Measurement Range : 1~999999L
Model Number : LC-02
DIY Supplies : ELECTRICAL