Installation steps
1. Do not wipe the original threshold with a damp cloth before pasting. Make sure the threshold is dry
2. Before installation, you can directly clean the original threshold with a dry towel or alcohol
3. Before operation, check the exact position of the threshold, tear off the protective film,and stick it in the correct position
4. Press and hold the sticker for a few minutes to remove air bubbles
5. Do not wash the car within 24 hours. This can result in very high bond strengths
6. If the temperature is low during installation, you can use hot air or open the car to heat it, heat it at the exhaust port, and then paste it to strengthen the paste.
7. If there are some inappropriate areas in your vehicle model, you can cut the sticker appropriately