1 Set Drive Shaft Center Support Bearing with Rubber Isolator for Two‑Piece Prop Shaft Layouts, Reference 37230‑0K040 Size, Compatible with Large‑Pattern Joint 3.625 x 1.062 Dimensions
Restore Driveline Support – Carrier bearing stabilizes a two‑piece shaft to help maintain alignment and steady torque delivery in rear‑wheel‑drive layouts.
Verified Bearing/Joint Specs – Common pairing uses an outside‑snap‑ring joint measuring about 3.625 inches across caps with 1.062 inch cap diameter; verify yokes before ordering.
Fitment Reference – Frequently cross‑referenced under 37230‑0K040 for mid‑2000s to mid‑2010s applications; check bracket style and bearing bore against the unit on the vehicle.
Service Friendly – Replacement follows standard steps: index shaft phasing, access mid‑tunnel area, unfasten the support, press the bearing squarely, and torque hardware per service data.
Packaging – Sold individually to match typical driveline service, allowing inspection‑based replacement of the center support.
Description
This center support carrier bearing is sized for two‑piece prop shaft configurations that reference the 37230‑0K040 fitment and commonly pair with an outside‑lock universal joint of approximately 3.625 inches cap‑to‑cap by 1.062 inch cap diameter. The assembly uses a rubber isolator around the bearing to help maintain alignment and steady driveline feel under load. Installation involves indexing shaft phasing marks, opening access at the mid‑tunnel, removing the support bracket, pressing the new bearing into the carrier, and torquing fasteners to specification. Always confirm bearing I.D., bracket style, and joint dimensions against the parts on the vehicle to ensure a precise match prior to installation.