SPECIFICS:
Part Number:S21307, E9575, TRB5912-T
Part Type: Bushing Installation Tool
Manufacturer Part Number: S21307
Bushing Type: Wide Beam Bushing
APPLICATIONS:
Fit for Automann TS TRB5912
Fit for Dayton TS 334-1576
Fit for Euclid TS E-10729A
Fit for Flagg TS HT245
Fit for Gaff TS 13628
Fit for Hendrickson TS S-24691
CROSS REFERENCES:
Fit for BWP HE9AA-T
Fit for Dayton 334-936
Fit for Euclid E-9575
Fit for Hendrickson S-21307
Fit for Meritor R309575
Fit for Sirco SH2034
Fit for Tiger Tool 15040
HOW to USE?
Removal of Bushing：
Scribe the bushing orientation on the beam tube and compression tube.
The spring pins are not required to line up with the bushing holes during removal.
Tighten retaining nuts to remove slack. Thread on hammer adapter in the event the bushing becomes seized. Hook up hydraulics and begin removal operation.
After each 2 inch stroke, re-tighten nuts to take up slack. (Most bushing will require 3-4 adjustments)
Installation of Bushing：
Insert the bushing into compression cylinder.
Place the plunger on top of the bushing, align the mark on the bushing with the mark on the plunger. The 4 corresponding pins to the bushing type you are installing should seat into the bushing.
Tighten retaining nuts to remove slack. Thread on hammer adapter in the event the bushing becomes seized. Confirm the plunger is aligned with the scribed mark on the beam tube and the pins are still engaged in the bushing. Hook up hydraulics and begin installation operation.
After each 2 inch stroke, retighten nuts to take up slack. (Most bushing will require 3-4 adjustments)