Generator Water Heaters 120V 240V Self-circulating Engine Preheater heating generator Thermostat water heater pre heating generator jacket heater parts
1 .Heater should be intailed vertically and make heater outlet upwards.
2 .Heater should be mounted under generator base with bolts.
Pipe Installation Instructions
1.Pour out cooling liquid clearly
2 .Link pipe and fitting in the vacuum side of cooling system correctly and probably in I owe rest position. Then link heater inlet with steel tube of generator by using a 8mm hose and tighten up lathedog.
3 .Link heater outlet to pressure side of water pump by more than 160mm outlet pipe. Hose link heater outlet with pipe fitting of generator
4 .Don , t link heater outlet pipe to generator until we pour cooling liquid into outlet pipe fully. It aims to release air in the outlet pipe and prevent any freezing of cooling liquid and operation failure. After linking outlet pipe to generator, keep pouring water.
Warning:
1. Outlet pipe hose should be as straight as possible, and not be flat
2. Hoses should not be torisoned or ringed during installation.
3. Hose outlet pipe should not be higher than junction of generator.
Checking After Installation
1 .Check heater and pipes fitting whether they are installed correctly and firmly.
2 .Start generator. Check cooling liquid pipe, add water to correct water level and then check wether there is leakness or not. And stop and cool generator.
3 .Link heater outlet to pressure side of water pump by more than 160mm outlet pipe. Hose link heater outlet with pipe fitting of generator.
4 .You can feel warmth of outlet pipe or hose connecting to generator. Otherwise,switch off heater battery. Then release air and keep heater working.
5 .Ater a few mimutes, check whether generator and inlet hose become warm stably and inspect heater automatic working condition-open-close-open.
Warning:
1. Don't switch on until heater i