Product name: Engraving Liquid
Net: 150ml
Accessories: 5cm sponge brush

How to use:
1. Clean the surface of the material and shake the liquid to mix evenly.
2. Apply this product to the surface of the engraved object and apply it evenly on the surface of the material with a sponge brush.
3. It will take 5-10 minutes to dry and then you can perform engraving.
4. After the engraving is completed, the engraving liquid can be directly removed with clean water.

Function:
Wood, reduce burrs
Leather, avoid edge burns, more delicate patterns
Acrylic, enhance frosting effect, reduce melting edges
Stone, improve grayscale contrast, suitable for fine graphics

Note:
1. It is recommended to apply by brushing. The amount of liquid applied at one time should not be too much, just ensure that the surface of the material is evenly covered.
2. The drying time of this product will vary due to different ambient temperature, humidity and ventilation conditions.
3. The number of times this product is applied may vary according to the actual use conditions.
4. Please pay attention to the antifreeze storage of the product in cold areas or under low temperature conditions. The storage temperature must not be lower than 5℃.
5. This product is ready to use after opening. The unused materials should be sealed and used as soon as possible.