6ft USB RS232 to 3.5mm Serial Converter Adpater M1ni Ja-ck Stereo pl-ug cable
USB RS232 to 3.5mm Ja-ck serial cable for galileo board console cable
3.5mm 3P Ja-ck male
PL2303TA + ZT232chip
VCC, GND, TXD, RXDoptional
PC COM RS232 standard signals, not TTL
Standard Pinout: Tip-RX, Ring-TX, Sleeve-GND
Cable: 3C*28AWG+braid+AL, black P-VC jacket, 6FT cable
Support Win XP/9X, Win 7, Linux, CE, etc
About PL2303TAPL2303TA USB to Serial Bridge Controller
PL2303TA provides a convenient solution for connecting an RS232-like full-duplex asynchronous serial device to any
Serial Bus (USB) capable host. PL2303TA highly compatible drivers could simulate the traditional COM port on most operating
systems allowing the existing applications based on COM port to easily migrate and be made USB ready without having to
rewrite the COM port software application.
By taking advantage of USB bulk transfer , large data buffers, and automatic flow control, PL2303TA is capable of
achieving higher throughput compared to traditional UART (Asynchronous Receiver ) ports.When real RS232
signaling is not required, baud rate higher than 115200 bps could be used for even higher performance. The flexible baud
rate generator of PL2303TA could be programmed to generate any rate between 75 bps and 6M bps.
PL2303TA is exclusively designed for mobile and embedded solutions in mind, providing a small footprint that could easily
fit in to any connectors and handheld devices. With very small power consumption in either operating or suspend ,
PL2303TA is perfect for bus powered operation with plenty of power left for the attached devices. Flexible signal level
requirement on the RS232-like serial port side also allows PL2303TA to directly to any 3.3V~1.8V range devices.
Product Applications:
Single-chip upgrade solution for RS232 devices to USB interface
USB to RS232 converters/cables/dongles
Healthcare/Medical U